How to Install Design Junction Wall Art

Screws and Spacers for Pieces with Mounting Holes – Hard Wall

Step 1: Position on your wall where you would like the wall art to go.
Step 2: Mark the position of the mounting holes on the wall.
Step 3: Pre-drill into your mounting surface.
Step 4: Line the spacer up behind the wall art and drive suitable screws through the mounting holes.
Step 5: Tighten all screws till the wall art is secure.
Step 6: Enjoy your new wall hanging.

Screws and Spacers for Pieces with Mounting Holes – Plasterboard (Standard Interior Wall)

Step 1: Position on your wall where you would like the wall art to go.
Step 2: Mark the position of the mounting holes on the wall.
Step 3: If the piece is lighter than 4kg or if you have located a stud then skip step 4 and pre-drill holes instead.
Step 4: Install drywall anchors as per manufacturer instructions.
Step 5: Line the spacer up behind the wall art and drive suitable screws through the mounting holes.
Step 6: Tighten all screws till the wall art is secure.
Step 7: Enjoy your new wall hanging.

Flush Mount Screws for Pieces with Mounting Holes – Hard Wall

Step 1: Position on your wall where you would like the wall art to go.
Step 2: Mark the position of the mounting holes on the wall.
Step 3: Pre-drill into your mounting surface.
Step 4: Drive suitable screws through the mounting holes.
Step 5: Tighten all screws till the wall art is secure.
Step 6: Enjoy your new wall hanging.

Flush Mount Screws for Pieces with Mounting Holes – Plasterboard (Standard Interior Wall)

Step 1: Position on your wall where you would like the wall art to go.
Step 2: Mark the position of the mounting holes on the wall.
Step 3: If the piece is lighter than 4kg or if you have located a stud then skip step 4 and pre-drill holes instead.
Step 4: Install drywall anchors as per manufacturer instructions.
Step 5: Drive suitable screws through the mounting holes.
Step 6: Tighten all screws till the wall art is secure.
Step 7: Enjoy your new wall hanging.

Double Sided Tape, Command Strips or Hookand Loop Fasteners

Step 1: Clean the wall that you wish to mount the piece to, ensuring it is free of dust, grime, and debris.
Step 2: Place strips of your chosen adhesive product onto parts on the wall art where it will not be seen.
Step 3: Peel the backing and press firmly onto the surface for the manufacturers recommended time.