Step 1: Turn the bollard so that the base is visible.
Step 2: Thread each of the eight adjustable feet into the corresponding holes on the base.
Step 3: Turn the bollard upright
Step 4: Adjust each foot as required to make the bollard level.
Step 5: Enjoy your new garden feature.

Step 1: Locate or install a suitable concrete slab or paver.
Step 2: Position the bollard where you would like it to stay on the concrete mounting surface.
Step 3: Mark each of the fixed flanges eight holes on the mounting surface.
Step 4: Pre-drill an 8mm diameter by 55mm deep hole in the mounting surface.
Step 5: Position the bollard over the newly drilled mounting holes.
Step 6: Thread the 8 included concrete screw anchors into the flange and the mounting surface.
Step 7: Enjoy your new garden feature.

Step 1: Locate a suitable wooden mounting surface such as a deck.
Step 2: Position the bollard where you would like it to sit.
Step 3: Mark each of the eight holes in the fixed flange on the mounting surface.
Step 4: Pre-drill holes for your stainless-steel decking screws.
Step 5: Position the bollard over the newly drilled mounting holes.
Step 6: Put a washer on each decking screw and drive them into the holes in the flange and the deck.
Step 7: Enjoy your new garden feature.